General Type: Heavy duty industrial/commercial

Brand: Kohler, Kawasaki

Models: Kawasaki FH451V (15HP)

Horsepower: 15HP Kawasaki.

Type: 4 cycle gas, vertical shaft engines

Displacement: Kawasaki: 15HP=494cc

Settings: Kawasaki 15HP= 3600 rpm (+/-75 rpm), idle set at 1200 rpm (+/-75 rpm)

Exhaust Group: Single & dual exhaust canister muffler

Starter: Electronic Ignition with recoil starter

Thickness: 7 gauge steel

Fuel Tank: 6 gallon (19.0 litres) seamless polyethylene with integral cup holder.

Drive Wheels/Tires: 16x6.50-8 four-ply pneumatic tubeless, radius edge

Brakes: Dynamic braking through hydro drive system

Axles: 1" tapered

Handle Bars: 1-1/4" diameter

Type: Hydro drive with two variable displacement pumps and two cast-iron high torque motors

Hydro Pumps: Two Hydro-Gear pumps with dump valves for movement without running the engine

Drive Wheel Motors: Two 12 cu. inch cast-iron high torque motors

Hydro Fluid Cooling Group: 4qt. capacity nylon cooling reservoir, uses, SAE 20W50 fluid and

10 micron filter

Steering / Travel Control:: Independent handle controls for each wheel, squeeze to move from forward to neutral to reverse, neutral lock lever, speed range controlled with single lever (patented design), in-field tracking adjustment with tool provided

Parking Brakes: 7.5" drum, band brake, one on each wheel

Dump Valves: Allows for movement without engine running

Axles: 1" tapered motor shafts

Wire Harness: 14 gauge wire

Safety Group: Handle actuated operator presence system (patented design), blade / clutch and transmission interlock to engine kill

Forward Speed Range: 0 to 7.4 mph

Reverse Speed Range: 0 to 3.0 mph

Type: Out-front design with anti-scalp rollers

Construction: 7-gauge steel with 7-gauge (3/16") steel skirt

Cutting Width: 32"

Cutting Height Adjustment: Adjustable from 1-3/4" to 4-1/4" in 1/4" increments

Blade Engagement: Electric blade brake clutch with instrument panel switch

Caster Wheels: 9.4 x 3.5 smooth tread flotation, inner tubes, split rims, roller bearings, with quick pin removal

Spindles: Cast housing, taper roller bearing, low maintenance with top access grease fitting and grease overfill relief poppet

Spindle Pulleys: Split steel with easily removed taper hubs

Idler Pulley: 5" diameter pulley, welded and riveted construction, 1-3/8" O.D. Bearings

Idler Arm: Heavy duty idler arm of 1/4" channel steel

Cutter Deck Belts: B-section with Kevlar cord

Length: 74.0"

Width: 54.5"

Height: 43"

Weight 515 lbs.

Turning Radius: Zero